maniquick mq Perfect Instrucción Para El Uso página 72

Warranty Provisions
CONDITIONS FOR SERVICE UNDER GUARANTEE
1. SANICO Srl guarantees the absence of faults and mechanical defects and the
completeness of the product when it is sold.
2. Repairs can be done only at Service Centres authorized by SANICO Srl or by the
Authorized Distributor in the country where you have purchased the appliance.
3. The duration of the period of guarantee on the materials and on manufacturing
and operating defects is 2 years with effect from the date of sale, subject to all the
conditions for the Purchaser shown in the Instructions for use. The obligations of
guarantee do not cover expendable materials: electrode cups, elastic bands, power
supply cables etc..
4. Complaints relative to the product must be presented directly to the authorized
service centre. The service centre, on the basis of an agreement with the Vendor, is
competent to establish the cause and nature of the fault. The product will be re-
placed only if it cannot be repaired.
5. The owner of the product will provide autonomously for delivering and collecting
the product from the place of the repair under guarantee.
6. The time necessary for the repair under guarantee will be subject to the degree of
seriousness of the fault.
7. The responsibility of SANICO Srl under these conditions of guarantee will be lim-
ited to the amount paid by the Purchaser for the product in question.
The guarantee on the product will not be applied in the following cases
• certificate of guarantee filled in incorrectly or falsified; serial number (if applicable
for the specific product) damaged or removed;
• absence of commercial and financial documents (cash receipt, delivery note)
proving the purchase;
• opening or repair of the product by the Purchaser or by an unauthorized Service
Centre;
• defects following failure by the Purchaser to observe the rules for use, storage and
transport of the product shown in the relative technical and regulations documen-
tation, in which case the regulations of the aforementioned documentation which
have been infringed must be specified;
• penetration of foreign bodies or liquids inside the product;
• presence on the product of internal or external mechanical defects (cracks, signs of
a fall, chipped parts, etc.) consequent to the incorrect use, installation or transport
of the product;
• components or accessories subject to rapid wear and tear (electrode cups, elastic
bands);
72