Descargar Imprimir esta página

General Motors 92214931 Instrucciones De Instalación

Protectores de salpicaduras

Publicidad

Idiomas disponibles

Idiomas disponibles

Enlaces rápidos

SPLASH GUARDS
Part No: 92214931, 92214927, 92214928, 92214929,
92214930, 92229701 & 92229704.
Splash Guard Front
Please read instructions thoroughly before starting.
Contents:
Description
Left Hand Splash Guard
Right Hand Splash Guard
#10 x 3/4 Screw
Push Pin
Alcohol Wipes
Instruction Sheet
Tools Required: #2 Phillips Screwdriver, T15 Torx, Screw-
driver, 3/32 (2.5mm),5/16 (8mm), Drill Bit, Power Drill, Center
Punch, Hammer and Clean Cloth.
NOTE: Turning of front wheels to the left or right will allow for
additional clearance when installing the splash guards.
Installation Procedure
1. Clean and degrease body panel where splash guards are
to be located.
2. Using alcohol wipers or 50% alcohol and water, clean area
to be taped.
3. Parts and vehicle temperature must be between 61° F and
86°F (16° C and 31°C).
4. Remove existing screws (4), locations D and E. See figure
1.
5. Mount splash guard (3) and snap molded clamps (6) in place
around metal fender edge (7) at locations A and B. (See
figure 2).
6. Reinstall existing screws (4) in locations D and E while
holding part up and into body panel. See figure 1.
7. While holding splash guard (3) firmly against body panel
(7), mark and drill 3/32" (2.5mm) center pilot hole in location
F and 5/16" (8mm) hole in location C. See figure 1.
8. While holding splash guard (3) firmly against body panel
(7), install supplied #10 screw (2) in location F. Do not over
tighten.
9. Install supplied push pin (5) in location C. See figure 1.
10. Push forward on splash guard (3) and pull tape liner off using
tab (1) and apply 20-30 pounds of pressure along tape length
to ensure contact. See figure 1.
11. Repeat procedure for other side.
12. Guards can be cleaned with any commercially available
cleaner.
Splash Guards
ALL INFORMATION WITHIN
ABOVE BORDER TO BE
PRINTED EXACTLY AS
SHOWN ON 8.5x11 WHITE
16 POUND BOND PAPER.
PRINT ON BOTH SIDES,
EXCLUDING TEMPLATES.
TO BE UTILIZED IN
ACCORDANCE WITH
GMSPO SPECIFICATIONS
DATE
REVISION
05NV08
Qty
1
1
2
2
2
1
AUTH DR
CK
TITLE
PART NO.
6200 Grand Pointe Dr., Grand Blanc, MI 48439
FIGURE 1
FIGURE 2
05NV08
92228977
Part No.
INSTALLATION INSTRUCTIONS
Splash Guards
92228977
SHEET
1
6
SHEET
OF
1
6
OF

Publicidad

loading

Resumen de contenidos para General Motors 92214931

  • Página 1 6200 Grand Pointe Dr., Grand Blanc, MI 48439 SPLASH GUARDS Part No: 92214931, 92214927, 92214928, 92214929, 92214930, 92229701 & 92229704. Splash Guard Front Please read instructions thoroughly before starting. Contents: Description Left Hand Splash Guard Right Hand Splash Guard #10 x 3/4 Screw...
  • Página 2 6200 Grand Pointe Dr., Grand Blanc, MI 48439 Splash Guards Rear Please read instructions thoroughly before starting. Contents: Description Left Hand Splash Guard Right Hand Splash Guard #10 x 3/4 Screw Alcohol Wipes Instruction Sheet Tools Required: #2 Phillips Screwdriver, T15 Torx Screw- driver, 3/32 (2.5mm),5/16 (8mm), Drill Bit, Power Drill, Center Punch, Hammer and Clean Cloth.
  • Página 3 Français 6200 Grand Pointe Dr., Grand Blanc, MI 48439 BAVETTES GARDE-BOUE N° de pièce : 92214931, 92214927, 92214928, 92214929, 10. Pousser vers l’avant sur la bavette garde-boue (3) et retirer la 92214930, 92229701 et 92229704. doublure du ruban adhésif à l’aide de la languette (1), puis exercer une pression de 20 à...
  • Página 4 Français 6200 Grand Pointe Dr., Grand Blanc, MI 48439 Bavettes garde-boue arrière Prière de lire attentivement toutes les consignes avant de commencer. Contenu : Description Qté Bavette garde-boue de gauche Bavette garde-boue de droite Vis n° 10 x 19 mm (3/4 po) Tampons alcoolisés Fiche de consignes Outils nécessaires : Tournevis à...
  • Página 5: Descripción

    6200 Grand Pointe Dr., Grand Blanc, MI 48439 PROTECTORES DE SALPICADURAS 10. Empuje hacia adelante el protector de salpicaduras (3) y No. de parte: 92214931, 92214927, 92214928, 92214929, jale el protector de la cinta adhesiva con la lengüeta (1) y 92214930, 92229701 & 92229704.
  • Página 6 Español 6200 Grand Pointe Dr., Grand Blanc, MI 48439 Protectores contra salpicaduras Lea las instrucciones cuidadosamente antes de comenzar. Contenido: Descripción Cant. Protector de salpicaduras izquierdo Protector de salpicaduras del lado derecho Tornillos de 3/4” N° 10 Toallitas con alcohol Hoja de instrucciones Herramientas necesarias: Destornillador Phillips No.

Este manual también es adecuado para:

922149279221492892214929922149309222970192229704