- EN -
5.2
Suction mode
Attention! Dangerous electrical voltage!
Possible consequences: Death or severe injury.
Protective measures: Prior to starting up the unit, switch off the mains voltage of all units located in the
water.
Note! The electronics will be destroyed .
Never operate the unit without the filter element!
Plunge the extension wand with floating suction hose and nozzle into the water and vacuum the floor
►
of the pond/pool.
The green LEDs on the operating panel light up/flicker to indicate the water level in the tank.
►
• ... ••: The discharge pump switches on automatically and pumps the dirty water out of the tank.
−
•• ... •••: The maximum water level is reached. Excessive dirt has collected at the bottom of the
−
tank, the discharge pump can no longer pump out the dirty water.
The vacuum can be manually switched off with "Vac OFF" when required.
►
The discharge pump can be manually switched on with "Pump ON" when required.
►
Recommendation: Empty the unit to reduced the weight. This will make it easier to move the unit.
−
In order to switch off the vacuum during discharge press "Pump ON" and "Vac OFF" simultaneously.
−
Empty the tank via the discharge pump before carrying out cleaning and maintenance measures.
►
Recommendation: Vacuum up clean water and empty the tank again. This will wash out the dirt
−
particles.
Clean the unit after each use. (→ Cleaning and maintenance)
►
24