Black and Decker Price Pfister Kenzo 16 Serie Manual Del Usuario página 3

7
7A
7C
7D
7 TRIM FLANGE ATTACHMENT
Position Flange (7A) onto Valve (7B). Place Protective Washer (7C) on the short end
of the reversible Retainer Sleeve (7D). Screw Retainer Sleeve (7D) onto threaded
section of Valve (7B). Tighten Retainer Sleeve (7D) by hand until Flange (7A) is snug to
fi nished wall surface. If the short end of the Retainer Sleeve (7D) is too short, reverse
it to use the longer end.
8
8B
8A
8D
8C
8E
8 HANDLE ATTACHMENT
Screw Stem Extender (8A) onto the Valve Stem (8B). Thread Set Screw (8C) into Handle
(8D) and thread it in only three to four turns. Place Handle (8D) onto the Stem Extender
(8A) and tighten Set Screw (8C) by using the Hex Wrench (8E) that is provided.
Make sure Set Screw (8C) is securely tightened to Handle (8D).
9
9B
9A
3/4"
9 HOLE LOCATIONS FOR WALL MOUNT
Remove Front Cover (9A) from Wall Mount (9B). Use Wall Mount Screw Holes (9C) to
place the desired location. Using a punch or awl, tap the screw hole locations. Holes
must be vertically aligned.
7B
9B
9C
ENGLISH
10
10B
10 ANCHOR INSTALLATION
1
Drill two / " Dia. Holes (10A). If installing into a stud, drill two
4
use Anchors (10B). Insert Anchors (10B) into Holes (10A) and tap fl ush with wall.
11
11B
11D
11B
11 WALL MOUNT INSTALLATION
Place Wall Mount (11A) onto wall and insert Mounting Screws (11B) through Wall Mount
Holes (11C) and tighten until Wall Mount (11A) is fl ush with the wall. Do Not Over
Tighten! Insert Front Cover (11D) into Wall Mount (11A).
12
12B
12 DROP ELBOW & HOSE INSTALLATION
Apply PTFE plumbers tape on both ends of Pipe Niple (12A) (not included). Screw Pipe
Niple (12A) into the elbow inside the wall. The Pipe Niple (12A) is to project
from the fi nished wall. Screw Drop Elbow (12B) onto Pipe Niple (12A) and tighten until
Drop Elbow (12B) is properly positioned and fl ush to the fi nished wall.
Place Rubber Seal (12C) inside Hex Hose Fitting (12D). Connect Hex Hose Fitting (12D)
into Drop Elbow Outlet (12E) by turning Hex Hose Fitting (12D).
3
1
/ " Dia. holes and do not
8
11C
11A
12A
12E
12C
12D
10A
11C
1 / 4 "- 3 / 8 "
1 3
/ "- / "
4 8