Wireless Connection; Other Connections - Definitive Technology SuperCube 4000 Manual Del Usuario

RECEIVER
RECEIVER
SPEAKER LEVEL IN
3
(best for amps/receivers with no LFE/subwoofer or
pre-out jacks)
1. Power-off the amplifier/receiver and disconnect
the subwoofer from the AC socket.
2. Connect standard speaker cables from the speaker
output terminals of the amplifier/receiver. Most
amplifiers and receiver speaker terminals allow two
sets of wires to be connected to one terminal set
(one for the main speaker and one for the sub-
woofer). [IMPORTANT NOTE: One terminal on each
channel input is marked with a red band (+) and the
other is marked with a black band (–). Make certain
that you connect the wire from the red (+) terminal
of your amplifier or receiver to the red (+) terminal of
the subwoofer and the wire from the black (–) termi-
nal of your amplifier or receiver to the black (–) ter-
minal of the subwoofer. It is essential to connect all
speakers in the system to the amplifier in the same
way (in correct polarity). If you experience poor bass,
one or more of the channels may be connected in
incorrect polarity and needs to be rewired. Pay close
attention and connect positive to positive; negative
to negative on all channels.]
3. Connect the subwoofer to an AC power source
and turn it on (see page 7).
4. If the system is 2-channel, skip to step 8.
5. If the receiver is a multi-channel device, turn on
the receiver's power and access the "speaker setup"
or "speaker configuration" menu.
6. Set the subwoofer to "None" or "Off".
7. Set front L&R speakers as "Large".
8. Proceed to page 17 for subwoofer adjustment and
system tweaking.

WIRELESS CONNECTION

4
1. In order to connect the subwoofer wirelessly, you
must purchase an optional Definitive Technology
wireless adaptor kit.
2. Follow the directions supplied with the wireless kit
to connect the system.

OTHER CONNECTIONS

12V trigger (OPTIONAL): Connect a cable with 3.5mm
tip/ring male plugs to the 12V trigger output of the
system's receiver or preamp/processor for one-button
system turn-on.
IR Remote: In installations where the subwoofer is in
a cabinet or otherwise blocked, the remote will not
work. Connect an IR remote repeater eye (optional,
available from most audio/video specialty dealers) to
the IR remote jack on the subwoofer's amplifier panel.
Position the repeater eye within clear view of your main
listening position.
9