Electrical Connection; Operating Your Freezer; Temperature Control - Avanti CF210G Manual De Instrucciones

?
After plugging the appliance into a wall outlet, allow the unit to cool down for 2~3 hours
before placing food in the freezer compartment.

? Electrical Connection

Improper use of the grounded plug can result in the risk of electrical shock. If the power
cord is damaged, have it replaced by an authorized Avanti Products service center.
This appliance should be properly grounded for your safety. The power cord of this appliance is equipped
with a three-prong plug which mates with standard three prong wall outlets to minimize the possibility of
electrical shock.
Do not under any circumstances cut or remove the third ground prong from the power cord supplied.
Use of extension cords is not recommended.
This appliance requires a standard 115/120 Volts A.C.~/60Hz electrical outlet with three-prong ground.
The cord should be secured behind the appliance and not left exposed or dangling to prevent accidental
injury.
Do not use an extension cord with this appliance. If the power cord is too short, have a qualified
electrician or service technician install an outlet near the appliance.
The "POWER" light indicates that the freezer is properly connected to the electrical power. The light
indicates power supply, and will glow even if the temperature control dial is turned to "OFF", or the
compressor has failed to work and the compartment is not being cooled.
The "COMPRESSOR" light indicates that the compressor is on and running. The compressor should not,
under normal conditions, be running continuously unless the unit is in "Fast Freeze" mode.

? Temperature Control

? Your freezer has one control for regulating the temperature. The temperature control is located on
the lower right hand corner.
? The first time you turn the unit on, switch on the Fast Freeze switch and run for at least 2 hours
before putting frozen foods inside. This will ensure the cabinet is thoroughly chilled before food is
put in.
? Turn off the Fast Freeze switch.
? The range of the temperature control is from position" 1" the warmest to "6" the coldest. Adjust
the temperature control to the setting that best suits your needs. The setting of "4" should be
correct for home or office freezer use.
? To turn the freezer off, turn the temperature control to "OFF".
NOTE:
? Turning the temperature control to "OFF " position stops the cooling cycle but does not shut off
the power to the freezer.
? If the unit is unplugged, lost power, or turned off; you must wait 3 to 5 minutes before restarting
?
Warning

OPERATING YOUR FREEZER

?