Elite ARION Rollers Instrucciones Para El Uso página 11

ASSEMBLY
Your ARION roller should arrive fully assembled,
checked and ready for use.
USE
Before starting to use your ARION it is necessary to
adjust the centre distance of the rollers to make them
compatible with your bicycle's wheelbase.
This adjustment must be carried out as follows:
1) Measure the distance between the centres of the
wheels of the bicycle to be used on the ARION
(Fig.2). We will call this dimension "X".
2) The distance from the intermediate point between
the two rear rollers to the middle of the ARION front
roller, which we will call "Y" (Fig.3), must match or be
as near as possible to dimension "X" . The axle of the
ARION front roller must be positioned in the hole of
X
2
the ARION frame whose measurement given on the
graduated scale is closest to dimension "X" (Fig.4).
ATTENTION: Dimension "Y" must be equal to or
slightly greater than "X". The rollers can be
adjusted to adapt them to bicycles whose
wheelbase is 0944-1124 mm (37 to 44 inches).
3) To change Y it is necessary to shift the front roller
4) Fold the ARION until the drive belt
5) Loosen the drive belt
respective front and rear guides.
6) Unfold the ARION back into the open position.
7) Remove the rectangular covers
screwdriver if necessary), and the screws and
washers on both sides from the front roller, using the
Allen key F provided. (Fig. 5a - 5b)
8) Pull the roller out from its original position.
9) Position the roller in the appropriate seat in the
holes in the frame, so that X matches Y.
10) Refit the screws and the washers in the special
holes, but do not tighten them down.
3
4
D
E slackens.
E , making it come off the
B (using a
EN
.
11