ClearSounds CSC48 Manual De Instrucciones página 8

If your product is causing harm to the telephone network, the telephone
company may temporarily discontinue your telephone service. If possible,
they'll notify you before they interrupt service. If advance notice isn't
practical, you'll be given the opportunity to correct the problem, and you
will be informed of your right to file a complaint with the FCC notified
as soon as possible. Your telephone company may make changes in its
facilities, equipment, operations, or procedures that could affect the
proper functioning of your product. If such changes are planned, you will
be notified
.
Interference Information: Part 15 of FCC Rules
Some telephone equipment generates, uses, and can radiate radio-
frequency energy and, if not installed and used properly, may cause
interference to radio and television reception. Your product has been
tested and found to meet the standards for a Class B digital device,
as specified in part 15 of the FCC Rules. These specifications are
designed to provide reasonable protection against such interference
in a residential installation. However, there is no guarantee that
interference will not occur in a particular installation. If your product
causes interference to radio or television reception when it is in
use, you might correct the interference with any one or all of these
measures: (a) where it can be done safely, reorient the receiving
television or radio antenna. (b) To the extent possible, relocate the
television, radio or other receiver with respect to the telephone
equipment. (c) If your telephone product runs on AC power, plug
your product into an AC outlet that is not on the same circuit as the
one used by your radio or television.
INDUSTRY CANADA CS03 STATEMENT
This product meets the applicable Industry Canada technical
specifications. This is confirmed by the registration number. The
abbreviation, IC before the registration number signifies that
registration was performed based on a Declaration of Conformity
indicating that Industry Canada technical specifications were met. It
does not imply that Industry Canada approved the equipment.
Before installing this equipment, users should ensure that
it is permissible to be connected to the facilities of the local
telecommunications company. The equipment must also be installed
using an acceptable method of connections. The customer should be
aware that compliance with the above conditions may not prevent
degradation of service in some situations.
Repairs to certified equipment should be made by an authorized
Canadian maintenance facility designated by the supplier. Any repairs
or alterations made by the user of this equipment, or equipment
malfunctions, may give the telecommunications company cause to
8 – ENGLISH