Defiant DFI-7167-WH Guía Para El Uso Y Cuidado página 9

Installation (continued)
6
Mounting the solar panel
IMPORTANT: Caulk around the base and on top of the screw heads
after installation.
NOTE: Wrap any excess solar panel cable around the
cord management system (3) located on the rear of the
solar panel base. Leave enough loose cable to form a drip
loop (4).
□
Place the solar panel (H) against the mounting
surface ensuring that the arrow is pointing up
and mark the mounting holes.
□
If mounting to a wooden surface, drill two
3/32 in. holes into the mounting surface.
Install the two mounting screws (AA)
through the base and into the mounting
surface.
□
If mounting to wall board or brick, drill two
7/32 in. holes into the mounting surface.
Insert the wall anchors (BB) and attach the
base using the two mounting screws (AA).
7
Adjusting the solar panel
□
Rotate the solar panel (H) to the desired angle.
IMPORTANT: The solar panel must receive as much direct sunlight
over the course of the day as possible. Keep in mind that shadows
may block the sunlight from reaching the solar panel during the day.
8
Connecting the solar panel to
the light fixture
□
Carefully route the solar panel (H) cable to the
light fixture (B). Insert the end of the cable into
the cable from the side of the light fixture (B).
□
Leave enough loose cable to form a drip
loop (4).
IMPORTANT: Turn the control dial (D) on the side of the sensor to
the OFF position and allow the battery to charge with 3 to 7 days of
full sunshine before testing.
H
AA
D
W
9
Please contact 1-866-308-3976 for further assistance.
BB
H
3
H
B
4
HOMEDEPOT.COM
H