Operation; Adjusting The Sensitivity - Defiant DFI-7167-WH Guía Para El Uso Y Cuidado

Operation

1
Adjusting the lamp head
□
If needed, gently grasp the lamp head (A) and
tilt it up or down or side to side to adjust the
light coverage area.
2
Determining the motion sensor
detection zone
NOTE: When the control dial is set to the "TEST" position,
the light will operate during the day or night. The light will
stay on for 5 seconds after all motion is stopped.
NOTE: The motion sensor will need to completely warm
up (60 seconds) before beginning the setup process.
□
Turn the control dial (D) to the TEST position.
□
Turn the sensitivity dial (E) to the "L" position.
□
Perform a "walk test": walk in an arc across
the front of the motion sensor (C).
□
Watch the light (B). The light (B) will come on
indicating motion has been detected.
□
Stop, wait for the light (B) to turn off, and then
begin walking again.
□
Continue this process until the detection zone
has been established.
3

Adjusting the sensitivity

□
If needed during the "walk test", turn the
sensitivity dial (E) to the desired sensitivity
("L", "M", "H").
NOTE: The motion sensor is more sensitive to motion
moving across the front of the sensor. The motion sensor is
less sensitive to motion moving directly toward the sensor.
NOTE: The higher the sensitivity setting, the greater the
possibility of false triggering. To reduce false triggering,
turn the sensitivity dial to the "L" or "M" position.
TEST
OFF 60S
W
B
C
W
10
A
W
W
B
D
E
M
L H
E
M
L H