Echo SRM-261T Guia De Inicio Rapido

For Model:
CONTENTS LIST
U-handle assembly
Metal debris shield
Metal shield bracket
Shoulder harness
Hip pad
Harness ring assembly
Lower u-handle bracket (2 pcs)
INSTALL METAL SHIELD
Tools Required: 8mm x 10mm Open End Wrench, Screwdriver.
Parts Required: Metal Shield, Bracket, 3 - 5mm x 10mm screws
w/captivated flat and lockwasher (metal shield to gear housing),
2 - 5mm x 8mm screws, 4 - 5mm nuts, 4 - 5mm lockwashers (bracket to
shield and bracket to gear housing).
1. If necessary, remove nylon line head and plastic shield.
2. Loosely attach bracket (A) to shield (B) and attach to bottom of
gear housing (C) with screws and nuts provided. Tighten all
attaching hardware.
Install Blade
Tools Required: Locking Tool, T-Wrench.
Parts Required: 1 - 20mm Upper Plate, Grass Blade, Brush Blade or
Tri-Cut Blade w/Glide Cup, 1 - Lower Fixing Plate,
1 - 10mm L.H. Nut, 1 - 2x22mm Split Pin.
3. Install upper plate (D) on splined shaft. Blade installation requires
use of upper Plate (D) with 20mm pilot. Upper plate should be
retained for use with nylon line head.
4. Place Blade (E) over upper plate pilot, install the lower Plate (F)
and 10mm LH nut (G). Tri-Cut Blade (H) is installed with Glide
Cup (J).
5. Insert Locking Tool (K) through hole in upper plate and notch in
gear housing to prevent splined shaft from turning. Tighten nut
and secure with Split Pin (L).
X7502233800
INSTALLATION INSTRUCTIONS
U-HANDLE COMBO KIT
U-HANDLE COMBO KIT P/N 99944200562
SRM-261T S/N 06001001 - 06999999
S/N 07001001 - 07999999
Upper fixing plate (20-mm)
Lower fixing plate
Square nut
2 - plastic clips
8 mm bolt
8 mm washer
10mm L.H. nut
2 - 5x8 mm screws
3 - 5x10 mm screws with captivated washers
3 - 5x30 mm bolts
4 - 5mm lockwashers
4 - 5mm nuts
10 - split pins
NYLON HEAD
UPPER PLATE
BLADE UPPER
PLATE
X750000790
05/05