Installing The Mounting Plate; Installing The Lithium Battery - Defiant DFI-5996-WH Guía Para El Uso Y Cuidado

Installation (continued)
4

Installing the mounting plate

Route the junction box wires through the hole
in the mounting plate (D).
Place the mounting plate (D) against the
junction box.
When mounting to a wall, the "UP" arrow
must point upward.
When mounting to an eave, the "UP" arrow
must point toward the building.
Insert the small mounting bolt (EE) through
the mounting plate (D) hole located below the
threaded hole, and thread it into the center
hole of the mounting bracket (FF). Tighten the
bolt (EE) securely.
Firmly pull on the mounting plate (D) to
verify it is securely attached to the mounting
bracket (FF).
EE
6

Installing the lithium battery

Remove the lithium battery (HH) from the
packaging.
Remove the cover (2) from the battery
compartment on the rear of light fixture (B).
Insert the male battery connector (3) into the
female connector.
Place the lithium battery (HH) into the holder
and replace the battery cover (2).
Making the electrical
5
connections
If necessary, strip 3/8" of insulation from
junction box wires (1).
Insert the junction box wires into the side of
the terminal block and around the ground
screw. Tighten terminal block screws using
the mini-screwdriver (GG) and ground screw to
secure the wires.
FF
T
N
O
R
F
D
6
Insert the white wire from the junction box
into the terminal marked "N (White)".
Insert the black wire from the junction box
into the terminal marked "L (Black)".
Connect the bare or green ground wire
from the junction box to the ground screw
(marked with "GND").
UP/Haut/Arriba
GND
Terre
Tierra
1
3/8"
3
D
N (White/
Blanc/Blanco)
L (Black/
Noir/Negro)
B
2
HH