Operation (continued)
Using emergency lighting
8
backup
This light (B) has been designed with a battery backup
system. When the power to the light (B) goes out, the
rechargeable lithium battery (HH) will allow the light
(B) to operate with limited capabilities.
The light (B) will work only at night.
The light (B) will operate at a reduced light
output of 400 lumens (only the center LEDs (4)
will illuminate).
The ON-TIME is set to turn the light (B) off after
10 seconds once all motion has stopped.
9
Using manual mode
NOTE: Manual mode overrides the motion sensor (C) so
the light will operate full bright. This feature only works
at night and only for one night at a time. The motion
sensor (C) will reset to motion sensing mode after 6 hours
or sunrise, whichever comes first. Manual mode can be
toggled on and off using a wall switch.
Ensure the power to the light is ON and the
sensor has warmed up (60 seconds).
To turn manual mode on, switch the power
OFF–ON–OFF–ON at the wall switch within 3
seconds.
To turn manual mode off, switch the power
OFF–ON–OFF–ON at the wall switch within 3
seconds.
Care and Cleaning
To prolong the original appearance, clean the light fixture with clear water and a soft, damp cloth only.
Do not use paints, solvents, or other chemicals on this light fixture. They could cause a premature
deterioration of the finish. This is not a defect in the finish and will not be covered by the warranty.
Do not spray the light fixture with a hose or power washer.
When the power first goes out, the light (B) will
come on for 1 minute at night only.
When the power is restored, the light (B) will
come on for 1 minute during the day or night.
NOTE: If the power to the light fixture is off for more than
5 seconds, allow the motion sensor to warm up prior to
switching to manual mode.
OFF
ON
Less than 3 seconds
10
4
B
OFF
ON