Uline H-6873 Guia De Inicio Rapido página 2

1. Unpack and place the conveyor on the ground with
the roller wheels facing down. (See Figure 1)
NOTE: Requires at least two people.
Figure 1
2. Unscrew nut and cream colored washer closest to
the floor. (See Figure 2)
Figure 2
Cream
Colored
Washer
Nut
3. Insert the upper leg into exposed bolt and pull up to
align bottom hole to the original bolt hole. (See Figure 3)
Figure 3
Exposed
Bolt
Original Bolt
4. Once aligned with original bolt, tighten the
previously removed cream washer and nut.
5. Repeat steps 3 and 4 for opposite leg.
PAGE 2 OF 15
ASSEMBLY
6. Place leg support between the two upper legs.
(See Figure 4)
Figure 4
7. Insert the 5/16" bolt with the top of the bolt facing
down. (See Figure 5)
Figure 5
8. Tighten the 5/16" washer and 5/16" locknut to secure
the bolt using a wrench.
9. Insert casters into the upper leg. (See Figure 6)
NOTE: The casters with brakes go on legs at the
ends and in the middle of the conveyor.
NOTE: H-6873 casters with brakes go on legs
only at ends of conveyor.
Figure 6
5/16" Bolt
Caster
without
Brake
Caster
with
Brake
1021 IH-6873