INSTRUCTION
1. Power button
2. Button for adjusting the intensity and switching on
the out-door pulse
3. TYPE-C USB charging interface
4. Battery indicator
5. Lock switch
6. 1/4" thread for tripods
OPERATION
Keep the lock switch in the
the laser level or storing it. - IT IS VERY IMPORTANT
NOT TO DAMAGE THE PRODUCT!
1. Self-levelling mode
Turn the lock switch to the
cal beam and the horizontal laser beam will illuminate,
the device will be self-levelling, the indicator light is
green. (If the indicator light is red and the lines blin-
ked, it indicates that the lines are not level, please put
the laser level on the much flatter place, because the
self-leveling is about +/-4°).
Briefly press the power button
switches off and the vertical line works.
Briefly press the power button
line switches on and the vertical line switches off.
Briefly press the power button
line and the vertical line will be lit at the same time.
Turn the locking switch to the
level will stop working.
position when moving
position, both the verti-
, the horizontal line
again. the horizontal
again. the horizontal
position, the laser