Operating Modes - Frico SIReB Guía Rápida

Ocultar thumbs Ver también para SIReB:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 28
GB

Operating modes

Operating modes Air curtains
Factory settings gives manual control of fan
and heating is controlled by thermostat on/off.
Set parameter P04 to 1 (see parameter menu
on the next page) to get the thermostat to
control both fan and heating on/off.
General
Manual mode
Decrease the temperature setting below 5 °C
and the following symbols are shown in the
status window = manual mode.
In manual mode both fan- and heating steps
are controlled manually.
Fan over run
When heat has been activated the fan will
continue to run to cool down the unit. The
over run time is 180 seconds or shorter if the
internal temperature has dropped below
+30 °C.
18
SIRe Basic
Operating modes fan heaters water
Set the maximum fan speed, heating step and
desired room temperature. The thermostat
is controlling the room temperature by
increasing/decreasing the fan speed. When
the desired room temperature is reached the
actuator/valve will close and the fan stops.
Maximum fan speed is limited to step 4.
If Parameter P04 is changed from 1 to 0 (see
list of parameters on next page) the fan runs
continuously on set speed and the thermostat
controls the heating on/off.
Heat regulation
When the room temperature drops below
the set point temperature the first heating
step is activated. If temperature continues to
drop, another heating step is activated (see
description below parameters P.00).
Heat regulation
When the room temperature drops below the
setpoint, the valve is opening for heat.
System on/off
Press the ON /OFF button for 2 seconds
to switch off the system. The unit's safety
functions are still active when the system is
switched off, which means that the fan can
continue to run for a while.

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Sire basic

Tabla de contenido