Installer Menu - Frico SIReB Guía Rápida

Installer menu

Parameter menu
Keep pressed until P00 is shown in the
status window. Use arrow up/down to scroll
between the parameters.
Use arrow up / down to scroll between the
parameters.
Press once to change a setting in the
parameter menu. Flashing values can be
adjusted using the arrow up/down and then
confirm. Keep the
the status window. (Returning automatically
to the status window after about 50 seconds).
P 0 0
.
P 0 1
.
P 0 2
.
P 0 2
.
P 0 2
.
P 0 2
.
P 0 2
.
P 0 2
Parametrar description
P .00 Temperature difference heating steps
Sets the difference between heating steps in
auto mode for electric units, alternatively the
difference between fan speed steps for water
supplied fan heaters.
List of parameters
Parameter- Description
number
Temperature difference between heating steps alternatively
P .00
difference between fan speed steps.
P .01 Overheting alarm ON/OFF ON=1; OFF=0
P .02 Over run time when heat has been activated
P .03 Temperature limit for fan over run
P .04 Fan control
P .05 Display of unit internal/outlet temperature
P .06 - 13 Run time
pressed to return to
.
P 1 3
.
SIRe Basic
P .01 Overheating alarm ON/OFF
Possibility to block the alarm (only valdid for
units with internal temperature sensor). Note!
If the alarm function is blocked, it must be
ensured this does not affect the unit´s safety.
P .02 Over run time
Time when the fan continue to run when the
heat has been on.
P .03 Temperature limit for over run
Over run time is cancelled if the internal
temperature drops below this set value (only
valid for units with internal temperature
sensor).
P .04 Fan control
Choose (0) or (1) operating mode, read more
under section Operating mode.
P .05 Internal temperature
Prevailing internal temperature. Only the
peak value is shown when several units are
connected (only valid for units with internal
temperature sensor).
P .06 - P .13 Run time
Run time for fan and heating steps.
Setting Factory
range setting
0,5-10 1.0 °C (0,5 °C SWH)
1/0 1
10-300 180 seconds
10-40 30 °C
0 = air curtains
0/1
1 = fan heater
0-100
0-99999
GB
19