Tabla De Contenido; Arc Interface Connections - TTI TF830-RS232 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

CONTENTS
Instructions en Français
Bedienungsanleitung auf Deutsch
Instruziana in Italiano
Instrucciones en Español
This manual provides general information about the ARC (Addressable
RS232 Chain) system plus details specific to the TF830-RS232, e.g.
address and baud rate selection, commands, etc.
The TF830 Instruction Manual gives the specification, installation instruc-
tions and full details of manual operation for the TF830.
Page
INTRODUCTION
1
The ARC interface allows a collection of instruments, up to a maximum
2
of 32, to be connected to a single serial interface on a PC or other
2
computer system. Each instrument may then be uniquely addressed so
that commands for that instrument may be sent and ignored by all other
5
instruments connected to the interface. Additionally, ARC instruments
5
may be used on a simple RS232 interface in non-addressable mode
without modification.
7
Available as an option is the ARCTALK software package for IBM
8
compatible PCs. At the simplest level, ARCTALK provides realtime direct
8
control of instruments on the ARC bus from the PC's keyboard. However,
11
it can be used more effectively to create complete 'programs' within
which several instruments can be set-up and/or measurements read-
back; responses can be captured in a 'response' file for later use, eg.
13
by another application which could, for example, generate a graph of
14
the data.
14
17

ARC INTERFACE CONNECTIONS

The 9-way D-type serial interface connector is located on the instrument
19
rear panel. The pin connections are as shown below:
20
Pin
20
22
25
26
26
29
Pins 2, 3 and 5 may be used as a conventional RS232 interface with
XON/XOFF handshaking. Pins 7, 8 and 9 are additionally used when the
instrument is connected to the ARC interface.
Name
Description
1
-
No internal Connection
2
TXD
Transmitted data from TF830
3
RXD
Received data to TF830
4
-
No internal connection
5
GND
Signal ground
6
-
No internal connection
7
RXD2
Secondary received data (see diagram)
8
TXD2
Secondary transmitted data (see diagram)
9
GND
Signal ground
1

Publicidad

Tabla de contenido
loading

Tabla de contenido