Cabling - Atlantis Land WebShare 243WM Guia De Inicio Rapido

LAN( RJ-45)
Reset
POWER (jack)

1.4 Cabling

First you must connect the product to the ADSL line through
the RJ11 cable you have in equipment (in the port ADSL),
then connect to the RJ45 ports the PCs of your Lan or
others Switch. In the end. Once you've checked all the
connections, connect the AC Adapter to the WebShare
243WM Wireless MIMO ADSL2+ Router and then to the
socket. The product will carry on immediately a diagnosis
(60 seconds). Finished this the Led PWR, SYS (eventually
even the Led LAN, if connected to PCs) will be fixed green.
The Led ADSL, if suitably connected, at first will be flashing
Connect an UTP Ethernet cable to
one of the four LAN ports when
connecting to a PC or an office/home
network of 10Mbps or 100Mbps.
After the device has turned on, press
it to reset the device or restore to
factory default settings. The operation
is as below:
•
0-3
device.
•
3-5 seconds: no action.
•
10 seconds
restore
settings (this is used when
you can not login to the
router,
password).
Connect the supplied power adapter
to this jack.
ENGLISH
seconds: reset
or
to factory
e.g. forgot
the
above:
default
the
28