RFC1483 routed / IpoA routed
These are configuration parameters:
•
VPI: 0 or 1 (check with your ISP)
•
VCI: 38 or 50 (check with your ISP)
•
NAT:Enable
•
Encapsulation: please use LLC Routed. If You have
problem You have to check with your ISP about which
Encapsulation Method is adopted.
Select Use the following IP address
•
IP Adress: Insert your Public IP
•
Subnet Mask: Insert Netmask provided by ISP
•
Gateway: Insert router Default Gateway
Press Apply and then click on Save Config to Flash.
Now You can check on the section Status if connection is
up and You can begin navigation. For every other problem
refer to Manual or Multimedia Guide on attached cd-rom.
ENGLISH
38