Attaching The Fan Blades - HAMPTON BAY LUXENBERG 91136 Guía De Uso Y Mantenimiento

Assembly - Attaching the Fan Blades
2

Attaching the fan blades

NOTE: Your fan blades are reversible. Select the blade
side finish which best accentuates you decor.
□
Mount the fan blades (G) to the blade bracket (H) by aligning
the three key-slot holes in the blade (G) with the three posts
on the top of the blade brackets (H).
□
Hold the blade (G) close to the blade bracket (H) and press
the blade (G) down firmly. Ensure the key-slot holes are
properly seated on the blade arm posts.
□
While still holding the blade (G) down, firmly slide the
blade (G) away from the bracket (H) side until the blade (G)
engages in the locking mechanism (TT).
□
Make sure the locking mechanism (TT) at the rear of the
blade bracket (H) springs upward and butts against the edge
of the blade (G) indicating a secure connection.
□
Visually inspect the top of the blade bracket (H) to ensure
the locking mechanism (TT) is securely in place.
□
Repeat for the remaining blades (G).
Assembly - Attaching the Light Kit
1
Attaching the light kit
WARNING: To reduce the risk of electric shock, disconnect
the electrical supply circuit to the fan before installing the
light kit.
□
Remove the three screws (UU) from the light kit fitter
assembly (E).
□
Connect the wires exiting the bottom of the motor assembly
(D) by connecting the molded adaptor plugs together (blue
to blue, and white to white).
□
Slide the light kit (E) and secure it to the switch housing
using the three screws (UU) that were removed in the first
step.
H
E
12
D
TT
G
D
UU