HAMPTON BAY LUXENBERG 91136 Guía De Uso Y Mantenimiento página 8

Ventilador de techo luxenberg de 91.4 cm
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Assembly - Close-To-Ceiling Mount
1
Close-to-Ceiling Mounting
Remove the mounting bracket (A) from the canopy (C) by
loosening the two canopy screws (FF) located in the "L
shaped" slots.
Remove and save the two canopy screws (FF) in the round
holes. This will enable you to remove the mounting bracket
(A).
Remove the canopy bottom cover (K) from the canopy (C) by
pressing the three studs.
FF
GG
FF
Assembly - Hanging the Fan
1
Attaching the fan to the electrical
box
WARNING: To reduce the risk of fire, electric shock or personal
injury, mount to outlet box marked "Acceptable for fan support
of 35 lbs. (15.9 Kg) or less", and use screws provided with the
outlet box.
Pass the 120-Volt supply wires through the center hole in the
mounting bracket (A).
Install the ceiling mounting bracket on the outlet box by sliding
the mounting bracket (A) over the two screws (LL) provided with
the outlet box. If necessary, use leveling washers (not included)
between the mounting bracket (A) and the outlet box. Note that
the flat side of the mounting bracket (A) is toward the outlet box.
When using close-to-ceiling mounting, it is important that the
mounting bracket be level.
Securely tighten the two mounting screws (LL).
2
Routing the wires
Remove three of the six screws (JJ) and lock washers (KK)
(every other one) securing the motor collar to the top of the
fan motor housing (D).
Place the rubber gasket (AA) over the remaining three screws.
Make sure the slot opening is on top, then proceed to place
the ceiling canopy (C) over the collar at the top of the motor
(D).
Align the mounting holes with the holes in the motor (D) and
fasten, using the three screws (JJ) and lock-washers (KK)
removed previously.
A
Tighten the mounting screws securely.
C
C
AA
K
D
LL
8
JJ
KK
LL
A

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido