Cleaning And Maintenance Instructions; Removing The Batteries - Joycare JC-503 Manual De Instrucciones

9- Maintenance and cleaning set
10- Hair set
RECHARGE INSTRUCTIONS
Firstly check that electric power source corresponds to adaptor voltage requirement. The appliance
can be recharged by connecting the adaptor directly to the same. Before using for the first time,
leave the device to charge for at least 12 hours. To extend battery life it is advisable to recharge
it when completely flat and not to recharge for longer than 48 consecutive hours. Always unplug
appliance once battery is fully charged. The charge indicator light does not switch off or change
colour when appliance is fully charged. To operate the appliance when plugged in: switch hair clipper
off, plug in and allow a few seconds before switching on.
ADJUSTING CUT LEVEL
Cut level may be adjusted selecting one of the 2 trimming guides provided.
Attaching/changing the combs:
short comb for approx. 4-16 mm cutting height
long comb for approx. 19-30 mm cutting height
WARNING: insert or remove a trimming guide comb only if appliance is off.
Select and insert guide comb according to desired cut level.
Just fasten the guide comb onto the supports on the sides of the blades.
Make sure that both attachment grooves on the comb engage the lateral attachment tabs (2); a click
is heard when they engage properly.
• For increased cutting height push the cutting height button located on the back of the device (5)
3
Thinning hair out:
To thin hair out, move the hair shaper button (3) towards the left to the desired height; this accesses
the hair thinning device integrated in the cutting head. This function enables you to reduce hair
volume, obtaining a modern, shaggy look without altering the length of the hair.

CLEANING AND MAINTENANCE INSTRUCTIONS

Always switch off and unplug appliance before cleaning it. Never immerse the appliance in water.
Clean the outside of the appliance with a slightly moist soft cloth. Never use solvents or abrasive
products. Remove the trimming guide comb using the provided brush after use, clear blades from
body hair and hair. To ensure best operation and extend appliance life it is advisable to frequently
clean and lubricate the hair clipper head. Easy- to-clean removable hair clipper blades. Gently press
blades forward to remove them from appliance. Use the provided brush to clear from any hair,
reassemble blades and lubricate with 2/3 drops lubricating oil. Switch on appliance and operate for
a few seconds to allow correct head lubrication.

REMOVING THE BATTERIES

The device should be dismantled according to the following description in order to properly and
5