Uline H-5615 Guia De Inicio Rapido página 2

SAFETY RAILING MOUNTING
1. Select the proper mounting bolt to attach the
mounting plate to the safety railing vertical post: Use
round U-bolts for round post, J-bolts for angle post
and square U-bolts for square post.
2. Mount gate so the top gate sleeve is at the same
height as the safety railing top. (See Figures 1-2)
DANGER! Death or serious injury may occur if
improperly installed or used. Mounting plate
MUST be placed on opposite side of railing
post from mounting bolts.
3. Place mounting bolts around the safety railing
vertical post with threaded ends inserted through
the mounting plate holes.
4. Secure mounting bolts with washers and locknuts.
(See Figure 1)
Figure 2
Hex Head Cap Screw
Torsion Bars
(One on either
side of railing)
TORSION BAR ATTACHMENT
1. Torsion bars are required when mounting the gate
to a safety railing system.
2. Install torsion bars on both sides of railing with the
hex head cap screws and hex nuts. (See Figures 2-3)
TIGHTEN MOUNTING BOLTS
1. Fully tighten all mounting bolts and nuts.
2. Test gate to make sure it opens fully and
automatically closes completely.
3. If mounting bolt ends interfere with normal operation
of gate, trim bolt ends to approximately 1/4" from
locknut with hacksaw or cut-off wheel and deburr.
DANGER! A fall resulting in DEATH or SERIOUS
INJURY may occur if gate is improperly installed
or used. Gate must be installed to prevent
unintended passage or fall into elevation change
or other hazard. Gate must not open toward
elevation change or other hazard.
PAGE 2 OF 9
INSTALLATION CONTINUED
(Figures 1-2)
Mounting Plate Edge
Railing
Cross Member
Safety Railing Top
1/2-13 x 3½"
1/2 - 13 Hex
Nut (USed in
both places)
Figure 1
Safety
Railing Top
Mounting
Bolt
Vertical Post
Gate Sleeve
Hex Head Cap Screw
DANGER! Gate width
must be set for gate strike
plate to overlap structure
opposite the gate mount
so outside edge of gate
strike plate is aligned past
center of guardrail tube
as illustrated.
Gate Sleeve
Hex Head Cap Screw
Figure 3
Torsion
Bar
1/2-13
Hex Nut
DANGER! A fall resulting in DEATH or SERIOUS
INJURY may occur if gate is improperly
installed or used. Do not prop gate open, or
otherwise impede proper operation of the gate.
Gate must fully close automatically.
Mounting
Plate 3/8-16 Locknut
Flat Washer
Top Gate
Tube Panel
Gate
Strike
Plate
Bottom
Gate Sleeve
Gate
Strike
Plate
Hex Head
Torsion
Cap Screw
Bar
x 2
Gate
Strike
Plate
Sleeve
0521 IH-5615