Ejector; Controller Head Seal Kit - resideo Braukmann Kaltec Soft KS10S Instrucciones De Mantenimiento

6. Ejector

The following maintenance sets
are required for maintenance on
the ejector:
EK10S-B (for devices up to July
2013) with red nozzle holding
element or
EK10S-BN (for devices from
August 2013) with white nozzle
holding element
EK10S-B and EK10S-BN
outwardly vary in the colour of the
nozzle holding element (see
above).
1. Carry out steps 1 through 6 from
chapter 3 - Preparation.
2. Screw off the ejector's lid anti-clock-
wise and remove.
3. Remove sealing ring, spacer as well
as filter element.
4. Take out the nozzle holding element.
5. Take out the flat seal.
6. Check lenticular sieve for soiling and
rinse out in a container if necessary.
7. Insert the lenticular sieve with the
lenticular bulges downwards.
8. Insert the flat seal with the writing
upwards.
9. Check the nozzle for plugging.
10. Insert the nozzle holding element.
11. Re-insert the nozzle with the writing
upwards.
12. Insert the filter sieve, spacer piece
and seal ring.
13. Screw on the ejector's lid hand-tight
(without a tool).
GB

7. Controller head seal kit

The controller head seal kit EK10S-
A is needed for the replacement.
1. Carry out steps 1 through 6 from
chapter 3 - Preparation.
2. Remove the valve-head drive motor
after loosening the screw connection.
3. Pull off the position sensor plugs.
4. Loosen the screw connections and
remove the intermediate plate.
5. Screw out the valve block lid's
screws and remove the lid comple-
tely.
The following seals need to be
replaced during the maintenance of
the controller head seal kit:
Figure 1:
Pos. 2 + 3 + 4 + 5 + 6 + 7
All seal rings have to be coated
with the supplied lubrication.
6. Reassemble in reverse order
When screwing on the lid, make
sure when applying the screws that
the self-cutting screw enters the
same notch in the plastic. This is
best done by turning the screw one
rotation to the left until the screw
audibly jumps over the notch. After
that, screw in the screw all the way.
7 MU6H-1417GE23 R0620