English; General Instructions; 2, Safety Instructions - Denios FW 8 Manual De Instrucciones

English

1. General Instructions

No modifications or alterations can be made to the product without authorisation from the manufacturer, in the
event of this, the guarantee will be invalidated.
National standards and safety regulations must be observed.

2, Safety instructions

Before the product is used, it is to be checked for correct functioning. Should any defects appear, it must not be
used!
Only use for the intended purpose!
The load must not be left in raised position.
The drums must only be raised slightly for when being transported.
The bearing capacity given must not be exceeded!
Safety instructions for EX-model
Handling inflammable liquids, explosion-proof systems
The electrical conductivity of the wheels and wheel linings can be changed by the depositing of hindering
substances and also by chemical and mechanical influences in such a way that the allowable values laid
down in the standards are exceeded. In particular, dust, dirt and paint, acids and alkalis, overloads and
impact loads can lead to the discharge/conduction of electric/electrostatic energy to the floor being
reduced or completely interrupted.
Because of the abundance of influences unknown to us in the use of our products our guarantee with
respect to the electrical conductivity relates exclusively to the compliance with the permitted values of the
wheels in new condition on delivery laid down in the standards.
The constant observation of technical safety regulations such as e.g. compliance with the values with
respect to electrical conductivity in use is exclusively in the area of responsibility of the user.
The exchange of the wheels for a non-conductive version leads to a loss of the ATEX eligibility.
As a lashing strap only an antistatic model must be used. The exchange of the strap for a non-conductive
version leads to a loss of the ATEX eligibility.
Chemical and mechanical influences as well as the accumulation of obstructive substances can alter
electrical conductivity to such an extent that the permitted levels laid out in standards are exceeded. Dust, dirt,
paint, acids, leaches, overloading and impact loads, in particular, may impede or completely prevent electrical or
electrostatic energy from being relayed to the ground. For this reason, you must keep the device completely
clean, especially its wheels and castors, and you must not apply an extra layer of paint.
Because of the abundance of influences unknown to us in the use of our products our guarantee with
respect to the electrical conductivity relates exclusively to the compliance with the permitted values of the wheels
in new condition on delivery laid down in the standards.
The constant observation of technical safety regulations such as e.g. compliance with the values with respect to
electrical conductivity in use is exclusively in the area of responsibility of the user.
Only use DENIOS replacement parts when replacing components. Replacing with unsuitable parts will mean the
device is no longer ATEX-compatible.
Dźwignik do beczek Servo z uchw. obr.
181088, 181090, 115293, 115295
181089, 181091, 147723, 147722
Strona 9 z 24 Wydanie 01/2010