Installation Requirements; Installation; Required Tools - Sears Kenmore 580.75100 Manual Del Propietário

INSTALLATION REQUIREMENTS
Yourair conditioner will install intostandard doublehung
windows withactua]clearopening widthsof 22 to36
inches(559mmto 914mm)(FIG. 1).
Lower sash must open sufficientlyto allow a clear
vertical opening of 13 inches (331mm). Side Iouvem
and the rear of the air conditionermust have clear
air space to allow enough airflow through the
condenser for heat removal. The rear of the unit
must be outdoors, not inside a building or garage.
I 1_3,, _nE_ i_ Sash
13" min. Inner sill Winder
' • SilEx _
Interior w all ",J ....... Io ° FIG. 1
ELECTRICAL SERVICE
Check your available electrical service. The power
supply available must be the same as that shown
on the unit nameplate (foundon rightside of cabinet).
All models are equipped with a 3-prong service plug
to provide proper service and safe positive
grounding. Do not change plug in any way. Do not
use an adapter plug. If your present wall outlet does
not match your plug, call a qualified electrician to
make the necessary correcttons.
SAVE CARTON and this OWNER'S MANUAL for
future reference. The carton is the pest way to store
unit dudng winter or when not in use.
To avoid risk of personal injury, property damage,
or productdamage due totheweightofthis
device and sharp edges that may be exposed:
• Air conditionerscovered in this manual posean
excessiveweight hazard.Two or more people
are neededto move and installthe unit.
To prevent injury or strain, use proper lifting and
carrying techniqueswhen moving unit.
Carefullyinspect locationwhere air conditioner
will be installed.Be sure itwill support the
weight of the unit over an extendedperiod of
time.
Handleair conditionerwith care. Wear
protectivegloves whenever lifting or carrying the
unit. AVOID the sharp metal fins of front and
rearcoils.
Make sure air conditionerdoes notfall dudng
installation.
INSTALLATION HARDWARE
S
ITEM NAME OF PARTS Q"I'Y
A SHORT SCREW 11
B WOOD SCREW 5
C L BRACKET 3
D FOAM STRIP 1
E FOAM SEAL 1
F SIDE CURTAIN 2
G DRAIN PIPE 1
H SUPPORT BRACKET 1
REQUIREDTOOLS:
• Tight Fiffing gloves
• Standard screwddver
• Phillipsscrewddver
• Pliers
• Sharp knife
• 3/8-inch open end
wrench or adjustable
wrench
• 1/4-inch hex socket
and ratchet
• Tape measure
• Electhc ddll
• 1/4-inch ddll bit
/
-5-