Installation; How To Install - Sears Kenmore 580.75100 Manual Del Propietário

INSTALLATION
Pick a locationwhichwill allow you to blow the cold
air into the area you want. Windows used for
installation must be strong enough to support the
weight of the air conditioner, Good installation with
special attention to the proper position of the unit will
lessen the chance that service will be needed.
If air onndiaomr b blocked bya st_m_ window _m,_.,
see stap 9 on page 7 beforebeginning_o instafl.
HOW TO INSTALL
_IsIDE CURTAINS
Insert the side curtains into the guides of the air
conditioner. Fasten the curtains to the unit with
screws (ITEM A), as shown in FIG. 2.
ITEM A FIG. 2
_'_ FOAM STRIP
Cut the adhesive-backed foam strip (ITEM D) to the
windowwidth.
Remove the backingfrom the foam strip and attach the
foam strip to the undersideof the bottom window. (FIG. 3)
L_ ATTACH L BRACKET
• Use screws(ITEM A) to install the L brackets
on the outer sill as shown. See Fig. 5.
• The bracket helps to hold unit securely in place.
Be sure to place bracket edge flush against back
of inner sill. See FIG. 5.
• If air conditioneris blocked by stormwindow
frame, see step 9.
INNER SILL
OUTERSILL [TEMA INSIDE
OUTSIDE
L BRACKET
FIG. 5
1=_'_ DRAINAGE
First, be sure to insert the drain pipe into base pan
before installation.The air conditioner must be
installedwith a slighttilt(I/4") downward for proper
drainage of excess condensed water throughthe
drain pipe.
(ITEM D)
FIG. 3
_1 LOCATING UNIT IN WINDOW
Open the window and mark center line with pencil
on the center of the inner sill,as shown in FIG. 4.
INNER SILL
ROOM SIDE
DRAINCAP
DRAIN PIPE
_J_BASE PANREAR
DRAIN_BASE PAN BOTTOM
"_H_////////////_
FIG. 6
-6-