Horizon Global CQT76288 Instrucciones De Montaje página 4

1. Remove rear bumper fascia
(A)Gently pull back wheel well molding with the plastic trim tools to locate a plastic rivet (1 on each side). (B) Use the drill to remove 2 plastic rivets (each side) from
the plastic wheel well molding and facia (See Figure 2). Rivets can not be re-used. Replacements supplied. To remove rivet, insert small center punch or drill bit into
center to push pin through.
1. Remove rear bumper fascia
(C) Use a 8mm socket to remove 16 screws from bottom of fascia (8) each
side. You will have 3 plastic trim pieces that will come off from this – set
them aside for later.
©2019 Horizon Global™ Corp. - Printed in Mexico
1. Remove rear bumper fascia
(D) Remove 4 push rivets from the top facia area (Located under the tailgate
see Figure 3). Two trim pieces can then be pulled off.
Sheet 4 of 18 76288NP 3-15-19 Rev. A