Horizon Global CQT76288 Instrucciones De Montaje página 5

1. Remove rear bumper fascia
(E) Remove reflectors buy using the plastic trim tools. (F) Gently begin to remove the facia by using your plastic trim tools. Unclip the electrical on the passenger side
and remove the fascia.
2. Lower exhaust and disconnect sensor wiring: Use a 13mm socket to remove 2 nuts from the exhaust (1 each side). Next disconnect the back-up sensor wiring
and hands free sensor (Not shown). Lower tailgate to access upper mounting fasteners.
3. Remove bumper beam by using a 18mm deep socket on 8 M12 nuts (4 each side). Set the bumper beam to the side. Keep the nuts for hitch installation.
©2019 Horizon Global™ Corp. - Printed in Mexico Sheet 5 of 18 76288NP 3-15-19 Rev. A