Krüger & Matz KM0232FHD Manual De Usuario página 34

Base stand assembly instruction (KM0232FHD)
When you install the base, the need to face down flat on the TV platform. Before
installing (or removing) the stand, unplug the AC power cord from the AC outlet
before performing the operation, laying cushion in place the TV will be placed to
prevent damage to the TV.
Warning: Be sure to follow the instructions for installation, if the base is not installed correctly,
it may result in the TV falling over. To remove the stand, perform the steps in reverse order, the
base can not adjust the angle. During the installation process, being careful to avoid damage
to the TV and your hand caught and ground to the bottom of the TV.
34
Step 1
1. Flat base, the base will be one of the
pillars placed in the end seat, make
sure the screw holes on the base and
the base of the pillars aligned.
2. Let screws into the base of the hole
and tighten the screw.
3. In the same way to install another
base pillars.
Note: Please use standard screws
packaging operation.
Step 2
1. Install the screw holes on the back
of the base and the base pillars aligned
television reserved.
Step 3
1. Let the four screws into the screw
holes and tighten the back of the TV.
Note: Please use standard screws
packaging operation.
Owner's manual