Positioning; Activation; Preparation For Use; Power Supply - river systems MISTRAL 650R Manual De Usuario

riversystems.it
5A - POSITIONING
A minimum room must be guaranteed around the machine to allow its safe use, and maintenance operations
to be performed easily. Position the power cord so that it does not get in the way during use.
riversystems.it

6. ACTIVATION

6A - PREPARATION FOR USE
ATTENTION!
EN
riversystems.it
HANDLE THE MACHINE WITH CARE WHILE MOVING IT TO AVOID INJURY OR DAMAGE.
Before plugging the machine, follow the instructions below:
• Remove the machine from its packaging;
• Choose the sieve with holes of suitable diameter (photo D);
riversystems.it
• Secure the sieve (9) to the lid (3) by positioning and tightening the nuts (8 and 10), and the respective
washers (photo E and F), using the wrench (12);
• Place the lid with the grinding unit (3), on the bin (7);
• Place the closing ring (5) making sure that the slightly inclined edge of the external side is facing upwards
(photo B);
• Fix the lid (3) to the bin (7) closing the ring (5) by tightening the lever (photo C).
6B - POWER SUPPLY
riversystems.it
CAUTION!
THE MACHINE MUST BE CONNECTED TO AN ELECTRICITY NETWORK THAT ENSURES
THE CONTINUITY OF THE EARTH CIRCUIT.
The power supply line must be protected by suitably sized overcurrent protection devices, considering the
installed power and the power cable section. The use of adapted cables, multiple sockets and / or extensions
riversystems.it
is prohibited. To connect the machine to the power supply, plug it into a suitable electrical socket.
riversystems.it

7. OPERATION AND USE

ATTENTION!
riversystems.it
THE FOLLOWING OPERATIONS MUST BE PERFORMED BY PERSONNEL WHO HAVE
READ AND UNDERSTOOD THIS MANUAL.
CAUTION!
TO USE THE MACHINE WEAR EAR PROTECTORS AND PROTECTIVE GLASSES AGAINST
ANY BODIES PROJECTED WHILE WORKING.
7A - USE
riversystems.it
To use the machine follow the instructions below:
• Start the machine by positioning the switch (2) on I;
• Pour the feed to be grinded inside the hopper (1) a little at a time;
• Use the machine until the bin is full (7);
• Stop the machine by positioning the switch (2) on 0;
• Unplug the mill;
riversystems.it
• Unfasten the ring (5) and remove the lid (3);
• Empty the bin (7) of the processed feed;
• If necessary, use a sieve (9) with holes of different diameters (photo D) to further process the feed,
following the instructions in paragraph 6A.
riversystems.it
riversystems.it
riversystems.it
riversystems.it
riversystems.it
riversystems.it
riversystems.it
riversystems.it
riversystems.it
riversystems.it
riversystems.it
- 22 -
riversystems.it
riversystems.it
riversystems.it
riversystems.it
riversystems.it
riversystems.it
riversystems.it
riversystems.it
Copyright © River Systems - All rights reserved
riversystems.it
r
r