Rowenta AQUACERAM SO9030G0 Manual De Instrucciones página 10

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 14
SO9030 NC00001439
14/05/07
It is essential that you read these instructions and observe the following recommendations
1 - WARNINGS
• For your safety, this appliance complies with the applicable standards and regulations or commercial (Low Voltage, Electromagnetic Compatibility,
Environmental Directives, etc.)
• This appliance is designed for domestic use only. It is not to be used in industrial applications.
• The warranty will be invalid in the event of damage arising from incorrect use.
• Do not place your appliance directly beneath a wall socket.
• Do not operate your appliance in a dusty room or if there is a risk of fire.
• Each time before use, check that in general the appliance is in good condition, as well as the plug and the cord.
• Never insert any objects inside the appliance (e.g.: needles)
• If the power cord is damaged, it must be changed by the manufacturer, the After Sales Service or a similarly qualified person in order to avoid any danger.
This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and know-
ledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be
supervised to ensure that they do not play with the appliance.
• Do not pull the power cord or the appliance, even to unplug it from the wall socket.
• Completely unwind the cord each time before use.
• This product has been designed for domestic use only. Any commercial use, inappropriate use or failure to comply with the instructions, the manufacturer
accepts no responsibility and the guarantee will not apply.
2 - VERY IMPORTANT
• WARNING : IN ORDER TO AVOID OVERHEATING DO NOT COVER THE HEATER
• Do not touch the appliance with wet hands.
• Do not let water get into the appliance.
• Do not use this appliance near baths, showers, sinks or swimming pools.
• Do not use the appliance near inflammable objects and products (curtains, aerosols, solvents, etc.).
• Do not use the appliance when tilted or laid flat.
• DO NOT FORCE THE OSCILLATION BY HAND.
• In the event of prolonged absences: stop the appliance using button A position "
3 - VOLTAGE
• Before first use, make sure that the voltage being used corresponds to what is indicated on the unit and that the electrical installation is adapted to the
power level indicated.
• Your appliance can be used with a power plug without an earth connection. It is a class II appliance (double insulation
4 - SAFETY
• In the event of abnormal overheating, a safety device shuts down the appliance and then automatically restarts it once it has cooled. If the fault persists
or gets worse, a thermal fuse shuts the appliance down completely and it must then be taken to an approved service centre.
• If the unit tips over, a safety device automatically turns it off. When placed back in an upright position, it will once again begin to operate.
In both cases, a warning beep will occur and the "Signal-Protect" indicator (D) will light up.
5 - OPERATION
Before turning the unit on, make sure:
it is positioned as described in these instructions,
that it is placed on a flat and horizontal surface, and;
that the air intake and outlet grilles are free of all obstacles.
• Function Selection :
Select the desired function by turning switch A (3) to line up the marking on the switch with one of the following symbols:
: on
: cooling
: 1000W
: 1800W
• Indicator:
- On/Off indicator C (1), lights up when the unit is turned on.
"Signal Protect" indicator D (3), lights up in case of overheating or if the unit tips over.
• Thermostat:
Adjust the temperature setting, according to your own comfort, by turning button B (3).
• Frost-free setting
:
This setting enables you to automatically maintain the temperature above 0°C in a normally insulated room, whose volume corresponds to the power of your
appliance.
Plug in the unit and turn switch B (3) to line up the marking on the switch with the "
1000W or
1800W
• Cold ventilation setting
:
This setting enables you to use your fan heater as a cooling fan in summer.
16:14
Page 10
USE IN BATHROOMS (PROTECTION AGAINST SPLASHING)
The construction of this "IP21" appliance allows it to be used in all rooms of the house, including those where
there is a risk of vertical splashing (kitchen, bathroom, etc.).
The electrical installation of the room, the installation of the appliance and its use must however comply with the
standards in force in your country.
" and unplug it.
Min
Max
" symbol and turn switch A (3) to select one of the following:
GB
).

Publicidad

Tabla de contenido
loading

Tabla de contenido