Wittur WSG-S1.2 Manual De Instrucciones página 71

4 Mechanical installation
1. Unbolt screws (10).
)
Note!
Correctly adjust the air gap using every 2nd screw (10) / sleeve bolt (9)! Turn
the remaining three sleeve bolts just far enough into the stator to make sure
that they do not touch the flange or the end shield. Repeat this process with the
other three screws (10).
2. Slightly turn the sleeve bolts (9) using a spanner.
– If the air gap is too large, screw them into the stator (1.1).
– If the air gap is too small, screw them out of the stator (1.1).
1
– / turn changes the width of the air gap by approx. 0.15mm.
6
3. Tighten the screws (10), (for torques, see table ^ 15).
4. Check the air gap "s
^ 15).
5. If the difference between the measured air gap and "s
readjustment.
(
Stop!
Only for brakes with manual release
| Also check dimension "s" and readjust, if necessary ^ 29
}
Danger!
Brake may fail
If the manual release is not adjusted correctly the brake may fail.
Possible consequences:
| Severe injuries or material damage.
Protective measure:
| Observe dimension "s".
" near the screws (10) using a feeler gauge, ("s
Lü
j | BA 14.0197 | 11/2010
" see table
Lürated
" is too large, repeat the
Lürated
i
27