Publicidad
Idiomas disponibles
Idiomas disponibles
3. When red seal indicator light turns off, vacuum
seal process is complete. Vacuum view window will
release, and sealed bag is ready for storage.
(See Figure 3)
Figure 3
NOTE: When dry and moist lights flash, the drip
tray is full and needs to be emptied. Vacuum
and seal function will begin again after drip
tray is emptied.
INSTALL A ROLL
NOTE: Only FoodSaver® rolls fit in cartridge.
1.
Press power button. Power indicator light will
illuminate to indicate power is on.
2. Open the express bag maker lower seal and cut bar
by pulling forward, away from the appliance.
(See Figure 4)
Figure 4
3. Insert roll from either side of appliance and slide in
until it sets into notched out area. (See Figure 5)
Figure 5
PAGE 4 OF 18
INSTRUCTIONS CONTINUED
4. Pull bag material forward to white line, sliding edges
5. Close express bag maker lower seal and cut bar
MAKE A BAG FROM A ROLL
1. Turn lever to unlock position and pull bag from bag
of bag all the way to indicator line marked on
appliance. (See Figure 6)
Figure 6
by pushing all the way back until it stops. Turn
unlock/seal lever to seal position to make first
seal. (See Figure 7)
NOTE: Red seal indicator light pulses while seal
is being made. When red seal indicator light
turns off, the seal is complete. User cannot use
vacuum view window until red light turns off.
Figure 7
dispenser area to desired length. (See Figure 8)
IMPORTANT! Accurately measure the amount of
bag material needed by placing the food to
be sealed on the counter and pulling enough
bag material to fit the amount of food for each
bag. Leave 3" of space between bag contents
and top of bag.
Figure 8
0721 IH-6676
Publicidad
