Safety Warnings; General Warnings - Kemper 1810 Manual De Instrucciones

Thank you for purchasing one of our products. We recommend you carefully read this instruction manual: it
contains important information regarding safety regulations for use and maintenance of the appliance. It is also
recommended to keep this document carefully to consult in case of necessity.
1. This appliance can be used by children aged from 8 years and
above and persons with reduced physical, sensory or mental
capabilities or lack of experience and knowledge if they have been
given supervision or instruction concerning use of the appliance in a
safe way and understand the hazards involved. Children shall not
play with the appliance. Cleaning and user maintenance shall not be
made by children without supervision.
2. Keep the tool away from flammable materials (curtains,
combustible material, furniture, etc.). The appliance is to be kept out
of reach of children.
3. To use this appliance in total safety implies observing some basic
safety measures, such as: never use the appliance with wet hands or
feet, never expose the appliance to moisture or water, never leave
the appliance exposed to atmospheric agents, never disconnect the
plug by pulling the power cord or the appliance itself.
4. After finishing the work, turn off the product and leave the soldering
iron cool in the air; never put it under water in order to avoid electric
shocks. Do not touch metal parts of the soldering iron (tips or
resistances) when it is on, with your hands or other parts of the body.
High temperatures can cause severe burns.
5. Do not carry out any cleaning or maintenance without first
disconnecting the plug from the power supply.
6. If the power cord is damaged, it must be replaced by the
manufacturer or its service agent or a similarly qualified person in
order to avoid any risks.
1. Before using the tool, control its integrity, if there are any defective parts, or it has other conditions,
which could negatively influence its functions and safety. Remove all the packaging material and
make sure that the appliance is in good condition. If you have any doubt, do not use the appliance
and contact our After-Sales Service. Keep the packaging material (staples, nylon bags, etc.) out of
the reach of children.
2. Before plugging the soldering iron into a socket, check whether your voltage corresponds to the
rating label of the appliance. This appliance must be connected to an approved mains socket that
complies with the safety regulations on electrical systems for civil purposes. The electrical system
must be specific for the appliance rated voltage.
3. Do not leave the soldering iron on, if you do not use it; it causes an early oxidation reaching over-
temperatures which could compromise the duration of the resistances.
4. The appliance must be used only for its intended use, which is soldering iron. Any other use than
its intended purpose shall be deemed to be improper and hazardous. The manufacturer shall not
be held responsible for damages derived from misuse of this appliance.
5. Always unplug the appliance before performing any maintenance and whether it is not used for
long periods of time. Before inserting or removing the tips, unplug the appliance.
6. Never connect the power cord to extensions or triple plugs. Do not pull or damage the power cord.
The power cord must never be in contact with the hot surfaces of the soldering iron.
DT ISTR_1810_4/2012_REV.6_03/2020

SAFETY WARNINGS

GENERAL WARNINGS

1810
6/32