Hoover DOMINO HVE32 Manual De Uso Y Mantenimiento página 20

INSTRUCTIONS FOR USE
Important: Before cooking with the appliance for the first time, it is important to clean the cook top. Then turn on all the heating
elements, one as a time, with no pan on top, for 5 minutes on the maximum temperature setting. This will eliminate to the "new
smell" and make any humidity that had accumulated on the heating elements evaporate. This is also essential to ensure that the
electronic devices function properly.
CERAMIC GLASS COOK TOP WITH TOUCH CONTROLS
1. Description of the controls
1. On/off key (ON/OFF)
2. Burner element key (ON/OFF)
3. Setting display (residual heat)
4. "Less" key
5. "More" key
6. Dual-circuit key (ON/OFF)
9. Safety lock key
10. Dual-circuit pilot light
12. Safety lock pilot light
13. Decimal point on setting display
On: the burner setting can be adjusted
Off: the burner is disabled.
Touch controls
All operations are performed by means of touch controls (capacitive sensors) situated on the front of the cook top; there is a
display relating to each key.
Every action is confirmed by an acoustic signal.
2. Turning on and off
Touch the on/off button.(1)
The control is enabled: the setting level indicators (3) read "0" and
the decimal points (13) flash on and off.
The next step must be carried out within 10 seconds, otherwise the
appliance goes off automatically.
Turning on the burner
After touching the on/off key (1), a burner must be selected within 10
seconds as follows:
1. Touch the key (2) for the burner required.
A "0" appears on the corresponding display. The decimal point
on the display (13) comes on to show that the burner is on.
2. Adjust the setting from 1 to 9 by means of the "+" and "-" keys
(5/4).
The "+" and "-" keys have a repeat function: pressing and holding
one of these keys induces an increase or decrease in the setting
value of one unit every 0.3 seconds.
You can enable only one burner at a time so only one decimal
point will be on.
Turning off the burner
1. The burner must be on. The decimal point (13) for the burner
concerned must also be on.
2. Bring the setting down to "0" by means of the "-" key (4). After 3
seconds, the burner goes off automatically.
Turning off the burner instantly:
1. The burner concerned must be on and the decimal point (13)
for said burner must also be on.
2. If you touch the "+" and "-" keys (5-4) simultaneously, the
burner goes off immediately.
20