Technical Data - LaserLiner SuperCross-Laser SCL 2 Instrucciones Para Su Uso

Horizontal and vertical levelling:
Open the battery compartment (2) and insert batteries according to the symbols. Be sure to pay
attention to polarity. Release the transport restraint, put the ON/OFF switch (4) into its "ON" positi-
on. The cross laser will appear. The desired laser lines can be selected with the selection button (5).
Refer to Figures A, B and C on page 2 for application examples.
Important: The tilt function must be activated to perform horizontal and vertical levelling. Activate
this by releasing the transport restraint, put the ON/OFF switch (4) into its "ON" position. The tilt func-
tion will produce an alarm when the unit is outside its automatic levelling range of 4.5°. The alarm sig-
nal is audible and the lasers will shut off. When this happens, place the unit on a more even surface.
Slope mode:
Do not release the transport restraint, put the ON/OFF switch into its "OFF" position. Select and
switch on the laser with the selection button (5). Now slopes can be laid out. Refer to the applicati-
on example in Figure D on page 2. IMPORTANT: This mode cannot be used to perform horizontal
or vertical levelling because the laser lines are no longer automatically aligned.

Technical Data

Automatic levelling range
Accuracy
Operating range (depending on room illumination)
Laser wavelength
Laser class
Power supply
Weight
Operating temperature
Storage temperature
Order number
Subject to technical changes without notice
Note: Regularly check the calibration before use, after transport and after extended periods of
storage.
ENGLISH
SuperCross-Laser SCL 2
+ 4,5°
+ 5 mm / 10 m
20 m
635 nm
2M / < 5 mW
4 x 1,5V AA / ca. 60 h
0,5 kg
0°C ... +50°C
-10°C ... + 70°C
081.120A
05/2008
9