OBJ_BUCH-1015-001.book Page 15 Thursday, April 30, 2009 1:08 PM
Safety Notes
en
Warning: Read these instructions carefully, be
familiar with the controls and proper use of
the machine. Please keep the instructions safe
for later use. Before using for the first time,
ask for a practical demonstration.
Explanation of symbols on the machine
General hazard safety alert.
Read instruction manual.
Before handling the cutter, switch off
and remove the plug from the mains
supply. If the cable is damaged or cut
through while working, do not touch
the cable but immediately remove the
plug from the mains supply. Never use
the machine with a damaged cable.
Wear protective gloves, sturdy shoes
and long trousers.
Danger – rotating blade. Keep hands
and feet out of openings while the ma-
chine is running.
Pay attention that bystanders are not
injured through foreign objects thrown
from the machine.
Keep bystanders a safe distance away
from the machine.
Wait until all machine components
have completely stopped before
touching them.
STOP
Wear eye protection.
Wear ear protection.
Bosch Power Tools
Do not use the machine in the rain or
leave it outdoors when it is raining.
Do not stand on the collection box.
Operation
During operation, do not reach into the
chute assembly 8. The machine runs on for
a few seconds after being switched off.
Never allow children or people unfamiliar
with these instructions to use the machine.
Local regulations may restrict the age of the
operator. When not in use store the machine
out of reach of children.
This tool is not intended for use by persons
(including children) with reduced physical,
sensory or mental capabilities, or lack of ex-
perience and knowledge, unless they have
been given supervision or instruction con-
cerning use of the appliance by a person re-
sponsible for their safety.
Children should be supervised to ensure that
they do not play with the appliance.
Before switching on, the machine must be
assembled according to the enclosed in-
structions.
It is recommended for increased electrical
safety to use a Residual Current Device
(RCD) with a tripping current of not more
than 30 mA. Always check your RCD every
time you use it.
Use only extension cables that are intended
for outdoor use and are protected against
splashes of water.
Do not touch the plug or socket with wet
hands.
Do not run over, crush or pull the power sup-
ply cable or extension lead, otherwise it may
be damaged. Protect the cable from heat, oil
and sharp edges.
Other persons and animals should remain at
a distance of 3 metres or more when the ma-
chine is being used. The operator is respon-
sible for third persons in the working area.
F 016 L70 603 | (30.4.09)
English | 15