Tabla De Contenido; Safety Precautions - Mitsubishi Electric VL-100U5-E Manual De Instalación

Mitsubishi Lossnay Ventilator
MODEL:
VL-100U -E
5
VL-100EU
Installation Manual
Please ensure that the separate "Operating Instructions"
are handed over to the customer. Please ensure that it is
delivered to the customer.
■ Proper installation is necessary for the Lossnay to perform
at full potential and to ensure safety. Before proceeding
with the installation work, be sure to read through these
instructions.
■ The installation work must be done by an authorized dealer
or qualified contractor. Errors in installation can lead to
breakdowns and accidents.
■ Installation by the customer can lead to breakdowns and
accidents.
■ Electrical work must be done by a qualified and licensed
electrician employed by the dealer or contractor.
■ If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or a similarly qualified
persons in order to avoid a hazard. (VL-100U

Safety precautions

Hazards created by mishandling and their
severity are indicated by the following markers.
Warning:
This applies to mishandling or misoperation
of the product which could lead to a fatal or
serious injury.
Caution:
This applies to mishandling or misoperation
of the product which will lead to an injury or
damage to your home, household effects, etc.
Warning
- Do not install the unit and wall
switch in a bathroom or other
Prohibited
highly humid location.
- Electric shock or short circuits could result.
- Do not disassemble the unit more
Do NOT
than necessary or modify it.
disassemble.
- Fire, electric shock or injury could result.
(pull cord type)
-E
(wall switch type)
5
5
For Dealer and Contractor
Contents
Safety precautions .............................1
Dimensional outline drawing ..............2
List of included parts ..........................3
Before installation ..............................3
Mounting instructions .........................4
Wall-hole construction ......................4
Cutting air supply/exhaust pipes ......5
Attaching the mounting plate ...........5
Attaching air supply/exhaust pipes ..6
Attaching the main unit ....................6
Outdoor construction .......................8
Checks after mounting .......................9
Test run ..............................................9
-E only)
- Connect the product properly to
ground.
Connect the
- Malfunctioning or power leaks can
grounding
wire.
cause electrical shock.
- Use at the rated voltage.
- Fire or electric shock could result.
You must
- Make sure the outside air intake
follow the
instructions
opening is positioned so that it will
given.
not take in combustion gases or other
exhaust. Position the unit so that it
will not become covered with snow.
- If intake air is not fresh, oxygen could
become depleted in the room.
- Install the unit securely to a
sufficiently strong wall surface.
- Injuries could result if the unit falls.
- Connect wires securely to terminal
block connections so they do not
come out.*
- Poor connections could result in fire.
Eng-1
Page
1