Garden Treasures TA7004 Manual De Instrucciones página 4

ASSEMBLY INSTRUCTIONS
4. Place (FF) in holes in arms to cover the screws.
5. Stand up back (B) and align back post (E) and insert bolt
(CC). Note that (B) is marked "up" and "down". Be sure the
hole pockets are facing outward so (CC) can be threaded
below the surface and covered with large buttons (II). Thread
(CC) in with wrench (DD). Complete for both bolts and both
sides. After all bolts are inserted, place (II) in holes and tap in
with a hammer.
6. Place back (B/E) in between (C) at back of swing. Place
(CC) in pre-drilled hole and align with (B/E). Tighten nut and
repeat for other side. Insert (II) in holes and tap in with a
hammer.
7. Attach (B/E) to (A) using (EE). Complete this for both sides.
Push (FF) in the holes to cover the heads of the screws.
CC
B
4
Fig. 4
FF
Fig. 5
E
Fig. 6
Fig. 7
B/E
EE
A
DD
B/E
C
CC