Programming With Code Search; Identifying Codes For Your Remote - Jasco RM24940 Manual De Instrucciones

Programming With Code Search

If your TV, VCR, DVD player, DBS Satellite
System, Cable Box or CD player does not
respond after you have tried all the codes
for your brand, or if your brand is not listed,
try searching your code by following the
steps below:
1. Manually turn on the
device you wish to pro­
gram.
2. Press and hold the
CODE SEARCH until the
INDICATOR LIGHT
lights, then release CODE
SEARCH.
3. Press and release the
device button for the
device you are program­
ming. The INDICATOR
LIGHT will blink
once, then remain lit.
NOTE: For AUX program­
ming carry out program-
ming procedure on page
11 for the device you are assigning to AUX
prior to starting a Code Search.
4. Press and release ON•OFF until your
device turns off.
5. When your device turns off, press ENTER,
the INDICATOR LIGHT will turn off.
Identifying Codes From Your Universal
Remote
If you need to find the three-
digit code for your TV, DVD,
VCR, DBS System, Cable
Box or CD player after your
device is set-up, use this
procedure.
1. Press and hold CODE
SEARCH until the INDI-
CATOR LIGHT lights, then
release CODE SEARCH.
2. Press and release the
device button for the code
you are retrieving. The INDICATOR LIGHT
will blink once.
CODE
SEARCH
VCR
CBL
CD
SAT
ENTER
SEARCH
VCR
CD
CBL
SAT
14
INDICATOR
LIGHT
(BLINK)
AUDIO•AUX
AUX
CBL/SAT
DVD
ON•OFF
OFF
CODE
INDICATOR
LIGHT
(BLINK)
AUX
CBL/SAT
TV
TV
AUDIO•AUX
DVD