Housing Cover; Remote Control - Uline H-9330 Instrucciones De Montaje

3. Carefully tuck electrical wires back into housing,
align housing cover with housing, and secure with
three housing screws and three star washers.
(See Figure 14)
Warning! Ensure that all connections, set
screws and screws are securely tightened
before the next step.
4. To clean fixture, turn off power, wait for it to cool and
wipe it with a clean, soft cloth.
PROGRAMMING
6
2
1
3
4
5
7
1. Turn ON supply power to fan. Within 30 seconds,
press and hold FAN ON/OFF button on the remote for
five seconds. Remote and fan are connected after
hearing a long beep.
2. If remote cannot control the fan, ensure all wiring
connections are properly connected according
to the instruction manual. Ensure batteries are in
correct position. Check if any similar remote controls
are in use nearby and whether they work with the
same frequency.
NOTE: Low voltage of battery will affect the
sensitivity of the remote. Indicator light will
flash when battery voltage is low. Replace
batteries for better performance.
PAGE 5 OF 19
MOUNTING CONTINUED

REMOTE CONTROL

REMOTE FAN CONTROLS
1 ON/OFF
Lamp
Short press: ON/OFF
2
Long press: dimming
(hold for 3 seconds)
3 Speed: 1=low, 5=high
4 Direction
5 Timing Control
6 LED light
7 12V Battery
Figure 14
Motor
Housing
Housing
Screw
WALL BRACKET (OPTIONAL)
1. Use wood screws (not provided) to secure wall
bracket at desired mounting location.
(See Figure 15)
2. Place remote control into wall bracket.
3. If needed, mount cap onto top of remote control
using two wood screws (not provided).
Cap
Wall
Bracket
Figure 15
Star
Housing
Washer
Cover
Wood
Screw
Wood
Screw
0721 IH-9330