Step 3 - Connect To The Wireless Network - Tangent QUATTRO MKII Manual Del Usuario

< My Home Network
It is possible, and in some locations highly likely, that your radio will find more
than one wireless access point, in which case you can choose which one you
want to connect to. Turn the TUNE knob on the radio to see the ESSID for each
access point the radio has found.

Step 3 - Connect to the wireless network

When the ESSID for the access point you want to connect to is displayed on the
screen, press the SELECT button.
If your network is not configured to need an encryption code, the screen should
say:
Connecting to
network
Then:
Network OK
If the screen displays either:
Enter WEP key
Or:
Enter WPA key
Then the network is using one of the encryption systems: Wired Equivalent
Privacy (WEP) or Wi-Fi Protected Access (WPA). You therefore need to enter
the correct WEP or WPA code into the radio to get it to communicate with your
network.
Only the person who set up the network in the first place knows this code; if that
person is not you then you need to find out what it is.
After 3 seconds, the display goes into the code entry mode. To enter the code,
use the TUNE knob to select each character of the code in turn, pressing the
>
11