FEIDER Machines FRX600 Manual Del Usuario página 41

Minisierra circular 600 w + base de inglete
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

EN
or install an undamaged wheel. After inspecting and installing the
wheel, position yourself and bystanders away from the plane of the
rotating wheel and run the power tool at maximum no load speed for
one minute. Damaged wheels will normally break apart during this test
time.
j) Wear personal protective equipment. Depending on application, use
face shield, safety goggles or safety glasses. As appropriate, wear dust
mask, hearing protectors, gloves and shop apron capable of stopping
small abrasive or workpiece fragments. The eye protection must be
capable of stopping flying debris generated by various operations. The
dust mask or respirator must be capable of filtrating particles generated
by your operation. Prolonged exposure to high intensity noise may cause
hearing loss.
k) Keep bystanders a safe distance away from work area. Anyone
entering the work area must wear personal protective equipment.
Fragments of workpiece or of a broken wheel may fly away and cause
injury beyond immediate area of operation.
l) Hold the power tool by insulated gripping surfaces only, when
performing an operation where the cutting accessory may contact
hidden wiring or its own cord.
Cutting accessory contacting a "live" wire may make exposed metal parts
of the power tool "live" and could give the operator an electric shock.
m) Position the cord clear of the spinning accessory. If you lose control,
the cord may be cut or snagged and your hand or arm may be pulled into
the spinning wheel.
n) Never lay the power tool down until the accessory has come to a
complete stop. The spinning wheel may grab the surface and pull the
power tool out of your control.
o) Do not run the power tool while carrying it at your side. Accidental
contact with the spinning accessory could snag your clothing, pulling the
accessory into your body.
p) Regularly clean the power tool's air vents. The motor's fan will draw
the dust inside the housing and excessive accumulation of powdered
metal may cause electrical hazards.
q) Do not operate the power tool near flammable materials. Sparks
could ignite these materials.

Publicidad

Tabla de contenido
loading

Tabla de contenido