Cutting Angle Adjustment - FEIDER Machines FRX600 Manual Del Usuario


Conventional tools such as keyhole saws or knives generally give excellent results, though
the plunge saw can be used if a particularly neat, dust free cut is required or if there is a
danger of cutting pipes or cables.
13 MITRE BASE
13.1

Cutting angle adjustment

NOTE: The angle scale (25) shows mitre angles from 0° to 60° to the left,
and 0°to 60° to the right.
There are four degree scales is 0°, 15°, 30°and 45°on the angle scale
(26) which these locations represent the most common angles for cutting
operation.

Take out clamp (20), lift the lock lever for mitre scale (21) and loose extension rod (23).

If the desired angle is one of the most common angles for cutting, set the right edge of
extension rod (23) align scale mark to the required degree measurement on the angle
scale (26).
Note: The pointer of the display scale window (27) indicates the above
required degree measurement on the angle scale (25) at the same time.
(Refer to Fig. 7)

If the desired angle is not one of the most common angles for cutting, set the pointer (28)
of the display scale window (27) align scale mark to the required degree measurement on
the angle scale (25).

Tighten the lock lever (21) and make sure the extension rod (23) fixes firmly.
13.2 Installing and adjusting the clamp

Place the clamp subassembly (20) on the mounting column clamp(29) of work platform
with angle scale (22).
NOTE: There are no screws to secure clamp. The clamp subassembly will
secure itself to the work platform (22) when turning the knob to clamp the
work-piece.
Do not use your other hand to hold the clamp when tightening. Only turn
the knob to secure clamp to work platform.
NOTE: prior to estimate thickness of work-piece, adjust the height of clamp
to higher than work-piece which convenient for clamping work-piece
quickly.
13.3 Adjusting position of work platform with angle scale (22)
There is a lock knob on (30) the bottom of work platform (22) which adjusts position of work
platform at the workbench. Loose the work platform (22) by turning lock knob anticlockwise
and slide the work platform to desired position as similar to Fig. 8 shows. Finally tighten the
lock knob firmly.
EN