FEIDER Machines FRX600 Manual Del Usuario página 44

________________________________________________________EN
Safety instructions for all saws
Cutting procedures
a) DANGER: Keep hands away from cutting area and the blade. Keep
your second hand on auxiliary handle, or motor housing. If both hands
are holding the saw, they cannot be cut by the blade.
NOTE For circular saws with 140 mm or smaller diameter blades, the
"Keep your second hand on auxiliary handle, or motor housing" may be
omitted.
b) Do not reach underneath the workpiece. The guard cannot protect
you from the blade below the workpiece.
c) Adjust the cutting depth to the thickness of the workpiece. Less than
a full tooth of the blade teeth should be visible below the workpiece.
d) Never hold piece being cut in your hands or across your leg. Secure
the workpiece to a stable platform. It is important to support the work
properly to minimize body exposure, blade binding, or loss of control.
e) Hold the power tool by insulated gripping surfaces only, when
performing an operation where the cutting tool may contact hidden
wiring or its own cord.
Contact with a "live" wire will also make exposed metal parts of the
power tool "live" and could give the operator an electric shock.
f) When ripping, always use a rip fence or straight edge guide. This
improves the accuracy of cut and reduces the chance of blade binding.
g) Always use blades with correct size and shape (diamond versus round)
of arbour holes. Blades that do not match the mounting hardware of the
saw will run eccentrically, causing loss of control.
h) Never use damaged or incorrect blade washers or bolt. The blade
washers and bolt were specially designed for your saw, for optimum
performance and safety of
Further safety instructions for all saws
Kickback causes and related warnings
– kickback is a sudden reaction to a pinched, bound or misaligned saw
blade, causing an uncontrolled saw to lift up and out of the workpiece
toward the operator;