Operation; Power On/Off - Wohler CDL 110 Manuel De Instrucciones

Operation

5 Operation
5.1

Power on/off

Fig. 3: Initial display
36
ATTENTION!
Calibrate the Wöhler CDL 110 at fresh air, before
using it fort he first time (see chapter 8).
Plug in the power supply and the meter turns on
automatically with a short beep. The readings will
immediately appear in the display.
ATTENTION!
If the voltage is too high or low, "bAT" will flash in
the display. (Please see chapter 9 "Trouble shoot-
ing").
WARNING!
Risk of electrical shock!
Never touch the jack with wet hands!
Protect the power supply against water and mois-
ture!
Do not unplug the power supply by pulling the ca-
ble!
Do not use the power supply when the voltage
requirements of the recharger and the supply do
not match!
The display will show the current CO
temperature, humidity, date and time.
The air quality level is indicated as good, normal
or poor, see Fig. 3.
-value, the
2