LaserLiner PipeControlMobile-Camera Manual De Instrucciones página 6

Connection for control cable
2
When screwing the control cable to the VideoControl-Master
base unit on top, ensure that the arrow on the connector plug
points toward the groove of the respective device.
!
The sensitive contact pins of the connector only fit into the socket in this position and can be
damaged if not positioned correctly or used too forcefully.
Roll up push rod
3
To roll up the push rod properly,
push the cable into the reel.
!
The cable should not be rolled up by turning the reel.
Instructions for use
• It is absolutely vital to ensure that the PipeControlMobile-Camera does not come into contact with
chemicals, current, moving or hot objects. This can damage the device and put its user at risk of
serious injury.
• The camera head is not acid-resistant or reproof.
• The PipeControlMobile-Camera must not be used for medical examinations/examining people.
• The unit is not suitable for taking measurements close to dangerous voltages. Therefore always make
sure that conductive parts are at zero potential when carrying out measurements in the vicinity of
electrical systems. Safe isolation from the power supply and precautions to prevent systems being
switched on again must be ensured by implementing suitable measures.
• Clean the push rod with a damp cloth before rolling it up.
06 GB