TTGO TGWS Instrucciones Y Advertencias Para La Instalación Y El Uso página 11

05. Remove your hand or the cloth.
06. Now, turn the "Sun" trimmer CW to the desired setting(*), outside the "Test"
zone.
(*) - This value can be changed later with the procedure and values given in chapter 6.
• Calibrating the wind sensor (Quick reference guide - Step 5)
01. Turn the "Wind" trimmer CCW to "Test".
02. Wait for the red/green leds to stop flashing briefly and alternately. Rotate the
wind sensor blades and check: a) the motor must raise the awning; b) the sensor
must prevent the motor receiving any other commands (thus protecting the awning
against the wind); c) the Led must flash red briefly several times (= threshold ex-
ceeded).
03. Now stop the blades and after which: a) the Led must flash briefly red and green
alternately several times (= return to within threshold); b) the sensor must deactivate
the protection function: send a transmitter command to the motor, the awning should
respond.
04. Now, turn the "Wind" trimmer CW to the desired setting(*), outside the "Test"
zone.
(*) - This value can be changed later with the procedure and values given in chapter 6.
E
(TGWS only)
01 01
su sun
Desired value...
02 02
"L1" (green-red-)
fast flashing
klx klx
 Series of flashes
6
SETTING THE CLIMATIC SENSOR
TRIP VALUE
You must set the "trip value" of the climatic sensors, i.e. a value above (or below)
which the sensor trips and sends a wireless command to the receiver in which it is mem-
orized.
Note - During normal operation of the sun (TGWS only) and wind sensors, led "L1"
is off, even when the unit is transmitting control signals.
• Operation of the "WIND" setpoint (fig. 4) – The wind sensor, measures the
windspeed in real time; when it exceeds the setpoint, after 3 seconds the sensor trans-
mits the Up command to the motor and blocks manual controls.
When the windspeed drops below the setpoint, after 4 minutes the sensor sends a sig-
nal to the motor, thus releasing it to receive manual commands. After 10 minutes (about)
automatic operation is restored.
• Operation of the "SUN" setpoint (fig. 5) – The sun sensor (TGWS only)
measures the brightness of the sunlight in real time; when it exceeds the setpoint, after 2
minutes the sensor sends the Down command to the motor.
When the brightness drops below the setpoint value, after 15 minutes the sensor sends
the Up command to the motor.
Setting the "Sun" and "Wind" sensor setpoints (fig. E)
01. (TGWS only) Turn the "Sun" trimmer to the desired setting. Important – Set-
ting the trimmer to its maximum value (at the end of its CW rotation) disables the
Sun sensor.
03 03
wi wind
...
Desired value...
04 04
"L1" (green-red-)
fast flashing
Km Km/h Km/h
 Series of flashes
...
English – 6